Non-Inventables Machines and Software
Easel and Easel Pro will connect and work with machines using the open-source GRBL firmware, which is limited to Arduino-based controllers. If you do not have an Inventables machine, some settings in Easel may need to be adjusted to work properly.
- Machine won't connect (3rd Party Machine)
- Machine stops carving (3rd Party Machine)
- Grbl Machine Setup (3rd Party Machine)
- Non-Grbl Machine Setup (3rd Party Machine)
- Carves too small or large (3rd Party Machine)
- Reverse or Mirror Engraving (3rd Party Machine)
- Spindle Won't Turn On (3rd Party Machine)
- Add Easel's post-processor to your Vectric software
- Installing Fusion 360 Post Processor
- Using MeshCAM with Easel