Inventables Help Center home page
  • Shop
    • X-Carve Pro
    • X-Carve
    • X-Carve vs. X-Carve Pro
    • X-Carve Upgrades
    • Carving Bits
    • Materials
    • Machine Components
    • Shop All Categories
  • Easel
  • Resources
    • Projects
    • Blog
  • Forum Help
    1. Inventables
    2. X-Carve
    3. X-Carve Troubleshooting

    X-Carve Troubleshooting

    Follow New articles New articles and comments
    • How do I re-flash Grbl to my X-Controller/Arduino?
    • Carving in the air (X-Carve)
    • Machine Profile Set Up for X-Carve
    • Depth is wrong
    • How to restart a carve after losing power
    • Work Zero and Homing
    • Wrong COM port selected (Windows Only)
    • DeWalt Router Won't Spin
    • Wrong material selected
    • Feed rate and/or depth per pass is too high
    • Design carved in the wrong place
    • The bit broke
    • Rough edge cuts
    • Homing cycle fails (X-Carve)
    • Machine stops carving
    • E-Stop and Connectivity Issues with the X-Controller
    • Carving went off path
    • Computer fell asleep
    • Nuts and bolts were not tightened enough
    • Machine is not set to use homing switches
    • Wrong bit was used
    • One or more V-Wheels are loose
    • Part of the design was skipped
    • Lead screw pulley isn't driving the belt properly
    • Stepper motors aren’t running in the correct direction
    • The Z-axis lead screw isn't secured properly
    • V-Wheels are too tight
    • Delrin Z-axis nut is loose
    • Bit is loose in the collet
    • Material moves or comes loose
    • 1
    • 2
    • ›
    • »
    Ask the Community
    Email Support
    Call Support
    (312) 775-7009
    Inventables