Inventables Help Center home page
  • Shop
    • X-Carve Pro
    • X-Carve
    • X-Carve vs. X-Carve Pro
    • X-Carve Upgrades
    • Carving Bits
    • Materials
    • Machine Components
    • Shop All Categories
  • Easel
  • Resources
    • Projects
    • Blog
  • Forum Help
    1. Inventables
    2. X-Carve
    3. X-Carve Troubleshooting

    Articles in this section

    • How do I re-flash Grbl to my X-Controller/Arduino?
    • Carving in the air (X-Carve)
    • Machine Profile Set Up for X-Carve
    • Depth is wrong
    • How to restart a carve after losing power
    • Work Zero and Homing
    • Wrong COM port selected (Windows Only)
    • DeWalt Router Won't Spin
    • Wrong material selected
    • Feed rate and/or depth per pass is too high
    See more

    The bit broke

    • March 18, 2020 19:40
    • Updated
    Follow

    During a job, the bit snapped off.

    Possible Causes

    • Wrong material selected
    • Feed rate and/or depth per pass is too high
    • Facebook
    • Twitter
    • LinkedIn
    Was this article helpful?
    3 out of 12 found this helpful
    Have more questions? Submit a request
    Return to top

    Related articles

    • Feed rate and/or depth per pass is too high
    • Wrong material selected
    • How to restart a carve after losing power
    • Rough edge cuts
    • Color-Coded Bit Chart: Choosing the Right Bit
    Ask the Community
    Email Support
    Call Support
    (312) 775-7009
    Inventables